Settings Related To Sheet Counters - Fujitsu fi-7160 Operator's Manual

Chapter 8 Operational Settings

8.4 Settings Related to Sheet Counters

Checking and Resetting the Sheet Counters
■
Checking the Sheet Counters
The status of each consumable part can be viewed to
determine when to replace or clean the consumables.
The color of the counter gradually changes when a
replacement for a consumable is needed or when cleaning is
needed. The color of each counter changes as follows:
 Brake roller counter/pick roller counter
These counters turn light yellow when the sheet count after the
consumable replacement reaches 95% of the value specified in
"Replacement Cycle of Consumables [Life Counter Alarm Setting]"
(page 162) in the Software Operation Panel, and turn yellow when the
sheet count reaches 100%.
 Cleaning counter
This counter turns yellow when the sheet count after cleaning
reaches 100% of the value specified in
[Cleaning Cycle]" (page 162) in the Software Operation Panel.
 Ink counter
This counter turns yellow when the amount of remaining ink reaches
below 33% (only displayed when the imprinter is installed).
"Scanner Cleaning Cycle
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 143).
2
From the listing on the left, select [Device Setting].
In this window, you can check the following items:
Item
Total Count (ADF) Approximate total number of sheets
scanned through the ADF
After cleaning Approximate total number of sheets
scanned after cleaning
Brake Roller Number of sheets scanned after the
brake roller is replaced
The number of sheets is counted in
increments of 500.
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Description
Operational
Settings
TOP
Contents
Index
Appendix
Glossary
159