Fujitsu fi-7160 Operator's Manual page 185

Chapter 9 Operational Settings
3
Specify the width of each margin to fill in: top/bottom/left/
right.
ADF
T: top = 0 to 15 mm
T
B: bottom = -7 to 7 mm
R: right = 0 to 15 mm
Image L: left = 0 to 15 mm
L R
FB (fi-7260/fi-7280)
T: top = 0 to 15 mm
B
B: bottom = 0 to 15 mm
R: right = 0 to 15 mm
L: left = 0 to 15 mm
(in 1 mm increments)
The specified area is filled in white or black, according to the
background color.
ATTENTION
Note that if the target range of Page Edge Filler is too wide, some
characters near the edge may appear missing.
HINT
The color of the background is normally white. You can change
the background to black in the scanner driver.
For details, refer to the scanner driver's Help.
Depending on the value you specify, the bottom edge is filled in
as follows:
- 1 to 7 mm
Fills the margin in white, from the detected page bottom.
- -1 to -7 mm
Outputs the image without filling in the margin.
"Detected page bottom" refers to the bottom edge of the
scanned document detected by the scanner.
This setting can also be configured in the scanner driver. In that
case, Page Edge Filler of the scanner driver is used on the
output image.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
185