Fujitsu fi-7160 Operator's Manual page 125

Chapter 7 Replacing the Consumables
6
Attach the two new pick rollers on the shaft on at a time.
1 Insert the retaining clip of the pick roller into the slot.
2 Insert the retaining clip of the other pick roller into the slot.
ATTENTION
Confirm that the pick roller is installed properly. Otherwise, it may
cause feeding errors such as paper jams.
Make sure to insert the pick roller until it locks in place.
7
Attach the shaft.
1 Insert the left end of the shaft into the slot, and lower the other end
Pick roller
Retaining clip
Shaft
Slot
Pick roller
Retaining clip
2 Rotate the bushing to lock the shaft.
Shaft
Slot
gradually.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
Shaft
How to Use the
Operator Panel
Various Ways to
Scan
Bushing
Daily Care
Shaft
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
125