A Shadow Appears At The Top Or The Bottom Of The Scanned Image - Fujitsu fi-7160 Operator's Manual

Chapter 8 Troubleshooting
A shadow appears at the top or the bottom of the
scanned image.
Have you adjusted the offset (position to start the scan)?
Yes
Did you use the Page Edge Filler function to fill out the
shadow around the edge?
Yes
In [Device Setting] of the Software Operation Panel, adjust the offset in the sub-
scanning direction.
No
For details, refer to "Adjusting the Position to Start the Scan [Offset/Vertical
magnification Adjustment]" (page
In the scanner driver or in [Device Setting 2] of the Software Operation Panel, use
the Page Edge Filler function to fill out the shadow around the edge.
No
For details, refer to "Removing Shadows/Streaks that Appear around the Scanned
Image [Page Edge Filler (ADF)]/[Page Edge Filler (FB)] (fi-7260/fi-7280)" (page
184).
If the problem persists, check the items in
Service Provider" (page 159)
an authorized FUJITSU scanner service provider.
183).
"8.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
154