Fujitsu fi-7160 Operator's Manual page 174

Chapter 9 Operational Settings
Item
Document check area
specification for Multifeed
Detection
(page 197)
Intelligent Multifeed Function
(page 200)
Description
Selected range: Select this item to restrict the
area to run multifeed detection.
Enable / Disable (Middle): Specify whether to
enable or disable multifeed detection in the
selected area.
Start (Middle): Specify the start position of the
area in length (mm) from the leading edge of
the document.
End (Middle): Specify the end position of the
area in length (mm) from the leading edge of
the document.
When there is a paper of the same size
attached to a designated location on the page,
configure the scanner to memorize the location
of the attachment and not detect multifeeds for
that location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] or [Check
Overlapping and length] in either the scanner
driver or the multifeed detection setting in
"Specifying a Multifeed Detection Method
[Multifeed]" (page 195).
This setting can also be configured in the
operator panel.
Select to clear the overlap pattern (length,
location) memorized in Auto mode.
This setting can also be configured in the
operator panel.
Select to record the multifeed pattern on the
dialog box to check an image that is detected as
multifeed.
Specify whether or not to memorize the
multifeed pattern upon power-off.
Parameter/Value
[Selected range] check box
Enable / Disable
(When [Selected range] is selected)
0 to 510 mm (in increments of 2)
0 to 510 mm (in increments of 2)
Manual mode / Auto mode 1 / Auto mode 2
[Clear overlap pattern] check box
[Auto-Memorize MF Pattern (only when MF
images are displayed)] check box
Remember / Do not remember
TOP
Contents
Factory Default
Index
Not selected
Introduction
Disable Scanner
Overview
0 mm
How to Load
Documents
0 mm Configuring the
Scan Settings
Manual mode
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Not selected
Troubleshooting
Not selected
Operational
Settings
Do not remember
Appendix
Glossary
174