Chapter 4 How to Use the Operator Panel
■Counting documents
1 [Power] button
2 [Menu] button
3 [ ]/[ ] button
[Scan/Enter] button
4 [Scan/Enter] button
1
Press the [Power] button on the operator panel.
The [Ready] screen is displayed on the LCD.
2
Press the [Menu] button.
The [Settings Menu] screen is displayed on the LCD.
3
Press the [ ] or [ ] button and select [9: Doc Counting
Mode], then press the [Scan/Enter] button to confirm.
The [Doc Counting Mode (More documents)] screen is displayed
on the LCD.
4
Load a document in the ADF paper chute (feeder), and
press the [Scan/Enter] button.
The number of sheets that are scanned is counted.
The number of counted sheets is displayed in Count.
ATTENTION
Documents may not be counted correctly if a multifeed occurs
during scanning.
HINT
To reset Count, press the [Stop/Clear] button while the [Doc
Counting Mode (More documents)] screen is displayed.
To end Doc Counting Mode, press the [Stop/Clear] button for
more than three seconds while the [Doc Counting Mode (More
documents)] screen is displayed.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
75