Overview; Scanner; Documents; Configuring The - Fujitsu fi-7160 Operator's Manual

Chapter 2 How to Load Documents
ATTENTION
When you scan plastic cards, take note of the following.
- Up to three plastic cards can be loaded in the ADF paper chute
(feeder).
Note that you can only load one card at a time if the plastic card is
embossed.
- It is recommended to place the card face-down in the ADF paper
chute.
- Cards should be within the following specifications:
ISO7810 ID-1 type compliant
Size : 85.6 × 53.98 mm
Thickness : 1.4 mm or less (*1)
Material : PVC (polyvinyl chloride) or PVCA (polyvinyl chloride
acetate)
Make sure to check if the card can be scanned first.
*1: Up to 1.25 mm is supported for scanning at 300 dpi or less (80
ppm) in landscape when using the fi-7180/fi-7280.
This setting can be changed in the Software Operation Panel
to scan plastic cards with a thickness up to 1.4 mm.
For details, refer to "Scanning Thick Plastic Cards [Feed
Mode] (fi-7180/fi-7280)" (page
- Rigid cards may not be fed properly.
- If the surface of the card is dirty with grease marks (e.g.
fingerprints) and such, perform scanning after wiping the dirt off.
- Plastic cards cannot be scanned when the imprinter is connected.
- Scanning thick documents such as plastic cards will be falsely
detected as multifeed.
In that case, to scan documents successfully, use the multifeed
window display function of the scanner driver, use the Intelligent
Multifeed function, or disable the multifeed detection.
194).
HINT
When scanning semi-transparent documents, increase the
brightness for scanning to avoid bleed-through.
When you scan documents written in lead pencil, make sure to clean
the rollers frequently. Otherwise, the rollers will be contaminated
which may leave black traces on the document or cause feeding
errors.
For details, refer to "Chapter 6 Daily Care" (page
If multifeeds, pick errors or paper jams occur frequently, refer to
Troubleshooting" (page 137).
When you scan documents with the ADF, all documents must be flat
on the leading edge. Make sure that curls on the leading edge of the
documents are kept within the following range.
30 mm or more
(1.18 in.)
Feeding direction
3 mm
5 mm
or less
or less
(0.12 in.)
(0.20 in.)
Leading edge
Scanned side
108).
"8.3
30 mm or more
(1.18 in.)
Feeding direction
Leading edge
Scanned side
TOP
Contents
Index
Introduction

Scanner

Overview

How to Load

Documents

Configuring the

Scan Settings

How to Use the

Operator Panel

Various Ways to

Scan

Daily Care

Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
47