Chapter 4 How to Use the Operator Panel
Item
14: Vertical Streak
Select whether to enable or disable vertical streak
Detection
detection.
After enabling this setting,
LCD if a vertical streak may occur in images that
are scanned through the ADF.
[Clean glass!] also flashes on the second line in the
[Ready] screen.
Check the information, and then clean the glass.
For details about checking the information, refer to
"Checking the information" (page
For details about cleaning, refer to
Care" (page
Specify the level of sensitivity to detect dirt on the
glass when vertical streak detection is enabled.
Select [1: Low] to only detect large amounts of dirt
on the glass. Select [3: High] to also detect small
amounts of dirt on the glass.
Enable/Disable can also be configured in the
scanner driver or the Software Operation Panel.
Sensitivity can also be specified in the Software
Operation Panel.
15: Prioritize Panel
For the paper protection setting, prioritize the
Settings
operation panel setting over the Software Operation
Panel setting. You cannot prioritize the operation
panel setting over the scanner driver setting.
When [1: Paper Protection] is selected, the Paper
Protection setting of the operator panel is
prioritized.
When [2: Clear] is selected, the Paper Protection
setting is no longer prioritized.
16: Ope. Panel
Initialize the settings of the operator panel.
Initialization
Note that the language setting and any items
without a factory default setting are not initialized.
Description
flashes on the
71).
"Chapter 6 Daily
108).
Parameter (*1)/Value
-: No settings/values
1: Enable
2: Disable
Sensitivity:
1. Low
2: Normal
3: High
1: Paper Protection
2: Clear
1: Yes
2: No
TOP
Contents
Factory
Index
Default (*2)
Introduction
2: Disable
Scanner
Overview
Sensitivity:
2: Normal
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
2: Clear
Replacing the
Consumables
Troubleshooting
Operational
Settings
(*4)
Appendix
Glossary
81