Settings Related To Sheet Counters - Fujitsu fi-7140 Operator's Manual

Chapter 8 Operational Settings

8.4 Settings Related to Sheet Counters

Checking and Resetting the Sheet Counters
■
Checking the Sheet Counters
The status of each consumable part can be viewed to
determine when to replace or clean the consumables.
The color of the counter gradually changes when a
replacement for a consumable is needed or when cleaning is
needed. The color of each counter changes as follows:
 Brake roller counter/pick roller counter
These counters turn light yellow when the page count after the
consumable replacement reaches 95% of the value specified in
"Replacement Cycle of Consumables [Life Counter Alarm Setting]"
(page 140) in the Software Operation Panel, and turn yellow when the
page count reaches 100%.
 Cleaning counter
This counter turns yellow when the page count after cleaning reaches
100% of the value specified in "Scanner Cleaning Cycle [Cleaning
Cycle]" (page 140) in the Software Operation Panel.
 Ink counter
This counter turns yellow when the amount of remaining ink reaches
below 33% (only displayed when the imprinter is installed).
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 123).
2
From the listing on the left, select [Device Setting].
In this window, you can check the following items:
Item
Total Count (ADF) Approximate total number of sheets
scanned through the ADF
Total Count (FB) Approximate total number of sheets
(fi-7240) scanned on the flatbed (fi-7240)
After cleaning Approximate total number of sheets
scanned after cleaning
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Description Troubleshooting
Operational
Settings
TOP
Contents
Index
Appendix
Glossary
137