Settings Related To Scanning; Adjusting The Position To Start The Scan [Offset/Vertical Magnification Adjustment] - Fujitsu fi-7160 Operator's Manual

Chapter 9 Operational Settings

9.5 Settings Related to Scanning

Adjusting the Position to Start the Scan
[Offset/Vertical magnification Adjustment]
When the output position of the scanned image is not correct or
the image appears shortened/elongated (vertically), adjust the
offset and the vertical magnification in the following procedure.
ATTENTION
Normally, you should not have to make any adjustments as the factory
default settings are configured at appropriate values.
1
Start up the Software Operation Panel.
For details, refer to "9.1 Starting Up the Software Operation Panel"
(page 163).
2
From the listing on the left, select [Device Setting] and
click the [Offset] button.
3
Adjust the level of offset/vertical magnification as needed.
Offset Setting
Unit Select [Flat bed] (fi-7260/fi-7280), [ADF (front)]
or [ADF (back)] as the target for offset
adjustment.
Main Adjusts the horizontal (width) offset.
The value can range from -2 to +2 mm (in
increments of 0.5).
Sub Adjusts the vertical (length) offset.
The value can range from -2 to +2 mm (in
increments of 0.5).
Description
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
183