Fujitsu fi-7160 Operator's Manual page 175

Chapter 9 Operational Settings
Item
Number of paper feeding retries
(page 188)
Cleaning Cycle
(page 181)
Life Counter Alarm Setting
(page 181)
Vertical Streak Detection
(page 204)
Vertical Streak Sensitivity
(page 205)
Pick Speed
(page 188)
AutoCrop Boundary
(page 189)
Description
Configure this setting to change the number of
feeding retries when a pick error occurs.
This setting can also be configured in the
operator panel.
Specify the scanner cleaning cycle.
Select whether or not to display the cleaning
instruction message from the scanner driver.
Specify the replacement cycle for the
consumables.
Select whether to enable or disable vertical
streak detection.
Enable to detect vertical streaks (dirt on the
glass) when you perform scanning with the
ADF.
This setting can also be configured in the
operator panel.
Specify the sensitivity level to detect vertical
streaks (dirt on the glass) when vertical streak
detection is enabled.
This setting can also be configured in the
operator panel.
When you experience frequent multifeeds and
paper jams, the symptom may be improved by
slowing down the speed in which documents
are picked (fed).
This setting can also be configured in the
operator panel.
Specify whether or not to optimize (round up/
down) the fractional part of the scanned image
data.
Parameter/Value
1 to 12 times
1,000 to 255,000 sheets
(in increments of 1,000)
Show cleaning instructions:
Selected/Not selected
Pick Rollers / Brake Rollers:
10,000 to 2,550,000 sheets
(in increments of 10,000)
Enable / Disable
Low / Normal / High
Normal / Slow
Optimize / Round Down
TOP
Contents
Factory Default
Index
3 times
Introduction
Scanner
Overview
5,000 sheets
How to Load
Not selected
Documents
Pick Rollers:
Configuring the
200,000 sheets
Scan Settings
Brake Rollers:
200,000 sheets
How to Use the
Disable
Operator Panel
Various Ways to
Scan
Daily Care
Normal
Replacing the
Consumables
Normal
Troubleshooting
Operational
Settings
Optimize
Appendix
Glossary
175