Paper Protection Is Set Off Frequently; Scan - Fujitsu fi-7160 Operator's Manual

Chapter 7 Troubleshooting

Paper protection is set off frequently.

Do the documents meet the requirements described in
"Precautions" in "Conditions" (page
Yes
Is there any foreign matter inside the ADF?
No
Are the consumables (*1) installed correctly?
Yes
Are the consumables (*1) clean?
Yes
Are the consumables (*1) worn out?
No
Is the high altitude mode enabled in the Software
Operation Panel?
No
Use documents that meet the requirements.
41)? For details, refer to
No
Clean the ADF. If there is any foreign matter in the ADF, remove it.
For details, refer to
Yes
Install the consumables (*1) correctly.
For details, refer to
No
Clean the consumables (*1).
For details, refer to
No
Check the consumable counters and replace them if necessary.
For details, refer to
Yes
Disable the high altitude mode in the Software Operation Panel when using the
scanner in places lower than 2,000 m.
Yes
For details, refer to
"2.2 Documents for Scanning" (page
"Chapter 5 Daily Care" (page 91).
"Chapter 6 Replacing the Consumables" (page
"Chapter 5 Daily Care" (page 91).
"Chapter 6 Replacing the Consumables" (page
"Scanning at High Altitude [High Altitude Mode]" (page
Contents
Introduction
41).
Scanner
Overview
How to Load
Documents
How to Use the
101).
Operator Panel
Various Ways to

Scan

Daily Care
101).
Replacing the
Consumables
175).
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
133