Specifying The Sensitivity Level For Paper Protection [Paper Protection Sensitivity] - Fujitsu fi-7140 Operator's Manual

Chapter 8 Operational Settings
Specifying the Sensitivity Level for Paper
Protection
[Paper Protection Sensitivity]
Specify the sensitivity level to detect anomalies upon feeding
the documents when paper protection is on.
Documents are warped and deformed when documents are
not fed by the rollers properly.
To detect such a symptom and stop the scan, select [Low] to
only detect documents that are highly deformed. Select [High]
to also detect documents that are slightly deformed.
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 123).
2
From the listing on the left, select [Device Setting 2] 
[Paper Protection Sensitivity].
3
Specify the sensitivity level.
Low: Decreases the sensitivity level to detect warped documents.
Normal: Monitors warped documents in normal sensitivity.
Keep this setting for normal use.
High: Increases the sensitivity level to detect warped documents.
HINT
 To detect paper warp faster and stop the scan, select [High].
 To decrease the frequency of paper jam detection if paper jams
occur frequently in the feeder, select [Low].
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
150