Paper Protection Is Set Off Frequently - Fujitsu fi-7300NX Operator's Manual

Paper Protection Is Set Off Frequently

Check the following points
● Do the documents meet the paper requirements? (page 203)
● Is there any foreign matter in the ADF? (page 203)
● Are the brake roller and pick roller installed correctly? (page 203)
Are the brake roller and pick roller clean? (page 203)
●
Are the brake roller and pick roller worn out? (page 204)
●
Is the sensitivity level for the paper protection function set to high in the touch screen or the Software
●
Operation Panel? (page 204)
If the problem persists, check the items in
first, then contact the distributor/dealer where you purchased this product. Or, make an inquiry by
referring to the contact information at the Contact for Inquiries section in Safety Precautions bundled with
this product.
●
Do the documents meet the paper requirements?
Solution
Use documents that meet the requirements.
For details, refer to
●
Is there any foreign matter in the ADF?
Solution
Clean the ADF.
Remove any foreign matter from the ADF.
For details, refer to
●
Are the brake roller and pick roller installed correctly?
Solution
Install the brake roller and pick roller correctly.
For details, refer to
●
Are the brake roller and pick roller clean?
Solution
Clean the brake roller and pick roller.
For details, refer to
Before You Contact the Scanner Service Provider (page 213)
Documents for Scanning (page
Cleaning the Inside of the Scanner (ADF) with a Cloth (page
Replacing the Brake Roller (page 127)
Cleaning the Inside of the Scanner (ADF) with a Cloth (page
203
79).
and Replacing the Pick Roller (page
Troubleshooting
119).
132).
119).