Setting Originals - Ricoh Aficio 1075 Operating Instructions Manual

This chapter explains the procedure for placing the original on the exposure
glass and in the automatic document feeder (ADF), and setting original scan
area and orientation according to the placement method.
To correctly display the top/bottom orientation of the scanned original on a
computer, the correct placement must be chosen by setup on the control panel
and scanner driver.
There are two orientations for placing the original. See the table below.
Note
❒ Normally, the original size is
is used to make the original orientation easy to understand. If the actual orig-
inal size changes, a combination of original orientation and the orientation
specified on the control panel or scanner driver does not change.
Scanned original
Select the placement method.
Place the original.
(There are two original orienta-
tions.)
When scanned by the
delivery scanner, e-
Speci-
mail or document serv-
fy the
er
orien-
(Specified on the con-
tation.
trol panel)
When scanned by the
TWAIN scanner
(Specified by the Scan-
ner Control dialog box)
Original displayed on a compu-
*1
ter
*1
When sending a gray scale image file in the TIFF (single or multi-page) or JPEG for-
mat, the image may not appear in the same orientation as it was scanned in.

3. Setting Originals

or , but in the table below, a square original
Place the original on the ex-
posure glass.
Place the Place the
original so original so
that the top that the top
edge touches edge touches
the top left of the rear of the
the exposure exposure
glass. glass.
Place the original in the auto-
matic document feeder
(ADF).
Place the top Place the
edge of the original so
original first. that the top
edge is set
into the ADF.
43