Using Pure Ip In The Netware 5/5.1 Environment - Ricoh Aficio 1075 Operating Instructions Manual

NetWare Configuration
O O O O
Assign the printer to the created print server as follows.
A Click [Assignments], and then click [Add] in the [Assignments] group.
B In the [Available objects] box, click the printer created in step
click [OK].
C After checking the settings, click [OK].
Note
❒ If the printer works as configured, the name of the print server appears
as an attached user.

Using Pure IP in the NetWare 5/5.1 Environment

A A A A
Log on to the file server as an Administrator or an administrator equivalent.
B B B B
Run the NIB Setup Tool.
5
Reference
See p.60 "Running the NIB Setup Tool" .
C C C C
Click [Property Sheet] and click [OK].
The [Network board list] dialog box appears.
D D D D
Click [TCP/IP protocol].
E E E E
Click the IP address of the Network Interface Board which is to be config-
ured, and then click [Next >].
Note
❒ If you do not know which Network Interface Board you are configuring,
see the network configuration page to check the MAC address (Network
Address).
F F F F
Make sure that the MAC address and IP address are correct, and then click
[Finish].
The [NIB Setup Tool] window appears.
G G G G
Click [Configure].
The property sheet appears.
H H H H
Click the [General] tab, and then type the name of the print server into the
[Device Name] box.
I I I I
Click the [NetWare] tab, and then make the following settings.
A In the [Print Server Name] box, type the name of the print server.
70
L L L L
, and then