Ricoh Aficio 1075 Operating Instructions Manual page 598

Appendix
❖ ❖ ❖ ❖ Protocol configuration
You should use the following command to set the protocols to active or inac-
tive. If you set a protocol to inactive, all access settings set to use that protocol
will be disabled.
msh> snmp {ip | ipx} {on | off}
• "on" means active and "off" means inactive.
To change the protocol of an access settings, use the following command.
However, if you disabled a protocol with the above command, making it ac-
tive here will have no effect.
msh> snmp number active {ip | ipx} {on | off}
❖ ❖ ❖ ❖ Access configuration
You can configure the address of a host depending on the protocols used.
The Network Interface Board accepts requests only from hosts having ad-
dresses with access types of "read-only" or "read-write". Type "0" to have the
Network Interface Board accept requests from any host without requiring a
specific type of access.
msh> snmp number {ip | ipx} address
Note
❒ To specify the TCP/IP protocol, type ip followed by a space, and then the
IP address.
❒ To specify the IPX/SPX protocol, type ipx followed by a space, and then
7
the IPX address followed by a decimal, and then the MAC address of the
Network Interface Board.
The following is an example of how to configure registration number 3 with
the IP address 192.168.15.16.
msh> snmp 3 ip 192.168.15.16
The following is an example of how to configure registration number 3 with
the IPX address 7390A448, and the MAC address 00:00:74:62:5C:65.
msh> snmp 3 ipx 7390A448:000074625C65
IPP
Use the ipp command to configure the IPP settings.
❖ ❖ ❖ ❖ Viewing setting
The following command displays the current IPP settings.
msh> ipp
Example output:
timeout=900(sec)
auth basic
• The "timeout" setting specifies how many seconds the computer keeps try-
ing to access the network printer to send print jobs when no connection can
be made.
• The "auth" setting indicates the user authorization mode.
112