Ricoh Aficio 1075 Operating Instructions Manual page 608

Appendix
❖ ❖ ❖ ❖ SMTP port number configuration
The following command sets the port number of the SMTP.
msh> smtp port port_number
Note
❒ The acceptable value is 1-65535.
DNS
Use the dns command to configure or display the DNS (Domain Name System)
settings.
❖ ❖ ❖ ❖ View setting
The following command displays the current DNS settings.
msh> dns
❖ ❖ ❖ ❖ Using the DNS server obtained from the DHCP server
The following command sets the use of the DNS server obtained from the
DHCP server.
msh> dns dhcp {valid | invalid}
• If you use the DNS server obtained from the DHCP server, designate "val-
id". If not, designate "invalid".
If you set "valid", the DNS server from the DHCP server is prioritized.
7
❖ ❖ ❖ ❖ DNS server configuration
The following command sets the DNS server address.
msh> dns number server / server address
The following is an example for configuring an IP address of 192.168.15.16 on
DNS 1 server.
msh> dns 1 server 192.168.15.16
• You can register up to 3 DNS server numbers.
• You cannot use "255.255.255.255" as the DNS server address.
Domainname
Use the domainname command to display or configure the domain name set-
tings.
You can configure the Ethernet interface, the IEEE 1394 interface or the IEEE
802.11b interface.
❖ ❖ ❖ ❖ View setting
The following command displays the current domain name.
msh> domainname
122