Ricoh Aficio 1075 Operating Instructions Manual page 595

Network Boot
Use the set command to configure the boot method.
msh> set parameter {on | off}
• "on" means active and "off" means inactive.
Parameter
dhcp
Note
❒ When you use DHCP, the server also needs to be configured.
❒ DHCP takes precedence over all other settings.
Protocol
Use the set command to allow/prevent remote access for each protocol.
msh> set protocol {up | down}
Protocol
appletalk
tcpip
netware
netbeui
*1
scsiprint
*1
ip1394
lpr
ftp
rsh
diprint
web
snmp
ipp
*1
Available when the 1394 Interface Board is installed.
Note
❒ If you prohibit remote access using TCP/IP and then log out, you cannot use
remote access. If this was a mistake, you can use the control panel to allow ac-
cess by TCP/IP.
❒ When you prevent access via TCP/IP, you are also prevented from using
ip1394, lpr, ftp, rsh, diprint, web, snmp and ipp.
Meaning
DHCP (Dynamic Host Configuration
Protocol)
"up" means active and "down" means
inactive.
Remote Maintenance by telnet
7
109