Ricoh Aficio 1075 Operating Instructions Manual page 594

Hide thumbs Also See for Aficio 1075:

Table of Contents

❒ To get the above addresses, contact your network administrator.

❒ If you don't know the address to configure, use the machine's default settings.

❒ The subnet mask is the same as that for the Ethernet interface and IEEE

802.11b interface. When changing interface, the settings of the former are

❒ When installing the optional 1394 Interface Board, set the subnet so that it

does not overlap with the Ethernet interface or the 1394 interface.

Access Control

Use the access command to view and configure access control. You can also

specify two or more access ranges.

❖ ❖ ❖ ❖ Reference

❖ ❖ ❖ ❖ Configuration

msh> access ✩ range start-address end-address

• ✩ represents a target number between 1 and 5. (Up to five access ranges

can be registered and selected.)

Example: To specify accessible IP addresses between 192.168.0.10 and

192.168.0.20:

msh> access 1 range 192.168.0.10 192.168.0.20

❒ The access range restricts the workstations from which printing is possible

by means of an address. If you do not need to restrict printing, make the

setting "0.0.0.0".

❒ The entry is invalid if the start address is greater than the end address.

❒ Up to five access ranges can be specified. The entry is invalid if the target

number is omitted.

❒ When using a Web browser, telnet or SmartNetMonitor for Client/Admin,

you can use an IP address that has not been restricted by access control.

However, you cannot print from SmartNetMonitor for Client.

❖ ❖ ❖ ❖ Access Control Initialization

msh> access flush

❒ This restores the factory-default settings so that all access ranges become

Chapters

Table of Contents