Ricoh Aficio 1075 Operating Instructions Manual page 607

❖ ❖ ❖ ❖ Interval Configuration
You can specify the interval at which the printer synchronizes with the oper-
ator-specified NTP server.
msh> sntp interval polling_time
Note
❒ The factory default setting is 3600 seconds.
❒ You can set the interval from 16 to 16384 seconds.
❒ If you set 0, the printer synchronizes with the NTP server only when you
turn the printer on. After that, the printer does not synchronize with the
NTP server.
❖ ❖ ❖ ❖ Time-zone Configuration
You can specify the time difference between the printer clock and the NTP
server clock.
msh> sntp timezone +/-hour_time
Example: To set the time-zone difference to +8 hours:
msh> sntp timezone +08:00
Note
❒ The time is in 24-hour notation.
SMTP
Use the smtp command to configure SMTP (Simple Mail Transfer Protocol) set-
tings.
❖ ❖ ❖ ❖ View setting
The following command displays the current SMTP settings.
msh> smtp
❖ ❖ ❖ ❖ SMTP server name configuration
The following command sets the SMTP server name.
msh> smtp server / server_name
The following is an example for configuring an IP address of 192.168.15.16 on
SMTP server.
msh> smtp server 192.168.15.16
The following is an example for configuring a Host name of mail.xyz.com on
SMTP server.
msh> smtp server mail.xyz.com
Note
❒ You can configure the SMTP server name using a Host name or IP address.
❒ A maximum of 127 alphanumeric or numeric characters can be used.
Remote Maintenance by telnet
7
121