Ricoh Aficio 1075 Operating Instructions Manual page 601

Parameter
clear group
clear comment
Note
❒ You cannot use the computer name starting with RNP or rnp.
ROUTE
Use the route command to control the routing table.
This command allows you to configure and display routing information. You
can change the network configuration from remote PCs using this command.
Note
❒ The maximum number of routing tables are 16.
Commands
route add {host | net} desti-
*1 *1
nation gateway
route delete {host | net}
*1
destination
*1
route get {destination
route active {host | net} des-
*1
tination on/off
route add default gateway
route flush
*1
IP address
SLP
Use this command to configure SLP settings.
You can search the NetWare server using SLP in the PureIP environment of
NetWare5/5.1. To use the slp command, you can configure the value of TTL
which can be used by the SLP multi-cast-packet.
Note
❒ The default value of TTL is "1". A search is executed only within a local seg-
ment. If the router does not support multi-cast, the settings are not available
even if the TTL value is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
Settings
Clears the Workgroup name
Clears comment
Topics of setting
Adds a host/network route to "destination", and a gateway ad-
dress to "gateway" in the table. Host becomes the default setting.
Deletes a host/network route from the table. Host becomes the
default setting.
} Displays only route information corresponding to a specified
destination. When the destination is unspecified, all routing in-
formation is displayed.
You can turn the specified destination on or off. Host becomes
the default setting.
*1
You can set the default gateway address.
Deletes all routing information.
Remote Maintenance by telnet
7
115