Ricoh Aficio 1075 Operating Instructions Manual page 603

Parameter
key [key value]
auth [open|shared]
rate [auto|11m|5.5m|2m|1m]
Note
❒ When changing the Interface to IEEE 802.11b, see p.106 "TCP/IP address"
❒ When configuring the IEEE 802.11b TCP/IP, see p.106 "TCP/IP address"
Job Spool
Use this command to configure Job Spool settings.
Limitation
❒ You can only specify the LPR and IPP protocol.
Note
❒ This machine information cannot reload automatically when you confirm the
Job spool settings on the Web browser. Click [Reload] or [Refresh] on the Web
browser when you want to reload this machine information.
❖ ❖ ❖ ❖ Reference
The job spool setting appears.
msh> spoolsw
Remote Maintenance by telnet
Value to be configured
64-bit or 128-bit can be set.
Only 10 hexadecimal characters can be set
when using 64-bit or 26 hexadecimal charac-
ters when using 128-bit.
Also, set 0x as prefix.
To use this function, set the same WEP key
for all the ports that transmit to each other.
You can set the authorized mode when using
WEP. The specified value and the authorized
mode are as follows:
open: Open system authorized (default)
shared: Shared key authorized
You can set the IEEE 802.11b transmitting
speed.
The transmitting speed you specify here is
the speed at which data is sent. You can re-
ceive data at any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
7
117