Ricoh Aficio 1075 Operating Instructions Manual page 602

Appendix
Setting IEEE 802.11b
Use the wiconfig command to configure the IEEE 802.11b settings.
Limitation
❒ You can make settings when installing the optional 802.11b Interface Kit.
❖ ❖ ❖ ❖ View settings
The following command displays the current IEEE 802.11b settings.
msh> wiconfig
The IEEE 802.11b card information is displayed.
msh> wiconfig cardinfo
Note
❒ If the IEEE 802.11b interface is not working correctly, the IEEE 802.11b card
information is not displayed.
❖ ❖ ❖ ❖ Configuration
Parameter
mode [ap|802.11adhoc|adhoc]
7
ssid ID value
channel frequency channel no.
enc [on|off]
116
Value to be configured
You can set infrastructure mode (ap), 802.11
ad hoc mode (802.11adhoc) or ad hoc mode
(adhoc).
The default is 802.11 ad hoc mode.
You can set for SSID in infrastructure mode.
The characters that can be used are ASCII
0x20-0x7e (32 bytes).
A SSID value is set automatically to the near-
est access point if the setting has not been
made.
If the setting has not been made for ad hoc
mode, the same value as for infrastructure
mode or an "ASSID" value is set automati-
cally if the setting has not been made.
You can set the channel.
You can specify from following channel.
• Metric Version :1-13
• Inch Version :1-11
Set the same channel for all the machines you
are using.
You can enable or disable the WEP function.
To enable the WEP function, specify [on]; to
disable it, specify [off].
To start the WEP function, enter the correct
WEP key.