Ricoh Aficio 1075 Operating Instructions Manual page 430

Troubleshooting
❖ ❖ ❖ ❖ Alert Messages
Messages/Second messages
Hole punch receptacle is full.
Open finisher cover and emp-
ty punch receptacle.
dStaple (centre) is almost
empty.
NV-RAM has a problem.
Parallel I/F board has a prob-
lem.
4
Paper in staple tray. Open fin-
isher cover and remove pa-
per.
Selected paper tray is in use
for another function. Please
wait.
Shift tray has a problem. Call
service representative.
dStaple is almost empty.
Staple unit is in use for anoth-
er function. Please wait.
USB has a problem.
30
Description
Hole punch receptacle is full.
There are few staples remain-
ing in the stapler.
An error has occurred in the
optional memory unit.
An error has occurred in the
parallel interface board.
There is paper remaining in-
side the finisher.
The specified paper tray is in
use by another function such
as the copier function.
A malfunction occurs when
using the shift function.
There are few staples remain-
ing.
The staple unit is in use by an-
other function such as the cop-
ier function.
An error occurred in the USB
interface board.
Solution
Empty the punch receptacle.
Load more staples.
Turn the main power switch
off, and on. If the message ap-
pears again, call your sales or
service representative.
Contact your sales or service
representative.
Remove the paper remaining
inside the finisher.
Wait until the other function
has finished using the speci-
fied paper tray.
Contact your sales or service
representative.
Load more staples.
Wait until the other function
has finished using the staple
unit.
Contact your sales or service
representative.