Confirming The Connection - Ricoh Aficio 1075 Operating Instructions Manual

Confirming the Connection

A A A A
Make sure the LED of the IEEE
802.11b card is lit.
❖ ❖ ❖ ❖ When using in Infrastracture Mode
1.
If the IEEE 802.11b card is work-
ing, it is lit in orange. If the IEEE
802.11b (wireless LAN) is not select-
ed, it does not light, even if the print-
er power is on.
2.
If it is connected properly to a net-
work, the LED is green in infrastruc-
t u r e m o d e . W h e n t h e L E D i s
blinking, the machine is searching
for devices.
❖ ❖ ❖ ❖ When using in Ad hoc Mode/802.11
Ad hoc Mode
1.
If the IEEE 802.11b card is work-
ing, it is lit in orange.
2.
If it is connected properly to a net-
work, the LED is green in ad hoc
mode or 802.11 ad hoc mode. When
the LED is blinking, the machine is
searching for devices. The LED will
light after a few seconds.
B B B B
Use a Web Browser to check the
printer is connected properly. See
p.90 "Configuring the Network
I n t e r f a c e B o a r d w it h a W e b
Browser".
C C C C
Print the configuration page to
verify settings.
1
2
For more information about how
to print the configuration page, see
the Printer Reference 2.
ZGDH600J
Infrastracture Mode
You can check the machine's radio
wave status using the machine's con-
trol panel.
A A A A
Press the { { { { User Tools/Counter} } } } key.
B B B B
Press [System Settings].
C C C C
Press [Interface Settings].
D D D D
Press [IEEE 802.11b].
E E E E
Press [Wireless LAN Signal].
The machine's radio wave status is
displayed.
F F F F
After checking the machine's ra-
dio wave status, press [Exit].
1
2
ZGDH600J
Using the IEEE 802.11b (Wireless LAN)
7
103