Configuring Protocols; Configuring Tcp/Ip And Ipp For Printing - Ricoh Aficio 1075 Operating Instructions Manual

Hide thumbs Also See for Aficio 1075:

Table of Contents

Windows NT 4.0 Configuration

Configuring Protocols

These instructions are for configuring the Network Interface Board and Win-

dows NT to use the TCP/IP protocol and IPP.

Configuring the machine

Configure the machine to use the TCP/IP protocol.

• Make sure that the TCP/IP protocol is set to active. (The default is active.)

• Assign an IP address and make other settings required for using the TCP/IP

For more information about how to make the above settings, see the General

Settings Guide.

If DHCP is used to assign IP addresses, see p.138 "Using DHCP".

❒ After setting the IP address, use the ping command to make sure that it has

been correctly set.

Click [Start], point to [Programs], and then click [Command Prompt].

Type the following: (Example IP address is 192.168.15.16)

C:\> ping 192.168.15.16

If the address has been configured correctly, the following message ap-

Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32

If the address has been configured incorrectly, the following message ap-

Request timed out.

Configuring a Windows NT computer

These steps are for configuring a Windows NT computer to use the TCP/IP pro-

Open [Control Panel], and then double-click the [Network] icon. Make sure

that "TCP/IP Protocol" is listed in the [Network protocols] box on the [Proto-

❒ If the TCP/IP protocol is not installed, click [Add] on the [Protocols] tab to

install it. For more information about installing the TCP/IP protocol, see

Windows NT Help.

Table of Contents