Fluke 9100 User Handbook Manual page 164

Final Width = 215mm
8.A.2.2.6 Device-Dependent Errors (DDE)
A Device-Dependent Error is generated if the device detects
an internal operating fault (eg. during self-test). The DDE bit
(3) is set true in the Standard-defined Event Status Byte, and
the error code number is appended to the Error queue. The
8.A.2.2.7 Device-Dependent Errors Reported only Locally on the Front Panel Screen
The error list for local operations, which are not reported to the remote operator, is given below:
Note that the error number will not be presented on the screen
-7001,"Entry contains illegal characters"
-7002,"Entered value is outside the
allowed range"
-7016,"Bus address must be within the
range 0 - 30"
-7018,"Borderline must be within the
range 10.00 - 99.99 %"
-7019,"Entry does not match previous
password entry"
-9001,"Target too big"
-9002,"Target too small"
-9003,"Frequency too high"
-9004,"Frequency too small"
-9005,"Level too big"
-9006,"Level too small"
-9007,"Deviation too big"
-9008,"Deviation too small"
-9009,"Width too big"
-9010,"Width too small"
-9011,"Period too big"
-9012,"Period too small"
-9013,"Duty too big"
-9014,"Duty too small"
-9015,"Temperature too big"
-9016,"Temperature too small"
-9017,"High volt lvl equals low volt lvl"
-9019,"High volt lvl below low volt lvl"
-9020,"Low volt lvl above high volt lvl"
-9021,"Outside amp x freq profile"
-9022,"Syntax error"
-9023,"Number too big"
-9024,"Reached upper boundary"
-9025,"Reached lower boundary"
-9026,"Up range required"
-9027,"Down range required"
-9028,"No more ranges"
ALWAYS: record the total message content for possible use by the Service Center.
8-A4 Appendix A to Section 8: 9100 Maintenance — Error Reporting Subsystem
error description appears on the display, remaining visible
until the next key-press or remote command.
Errors are reported by the mechanisms described earlier in
Section 6, Sub-section 6.5, which deals with status reporting.
-9029,"Top of range"
-9030,"Bottom of range"
-9031,"Maximum value"
-9032,"Minimum value"
-9033,"Illegal rep/width combination"
-9034,"Illegal duty/width combination"
-9036,"No calibration for this function"
-9037,"THERMAL limit: reduced output"
-9038,"Printer is not responding"
-9039,"Printer out of paper"
-9040,"Invalid test number"
-9041,"Invalid loop counter"
-9042,"Illegal offset"
-9043,"No more failures to view"
-9044,"No more tests to execute"
-9045,"Nominal Resistance too big"
-9046,"Nominal Resistance too small"
-9047,"Maximum positive phase angle"
-9048,"Maximum negative phase angle"
-9049,"Cannot change: ref out still
selected"
-9050,"Cannot change: delta
selected"
-9051,"Freq too big: 1kHz max when
ref out active"
-9052,"Freq too big: 1kHz max when
delta active"
-9053,"Previous test point failed:
exceeded UUT spec. limits"
-9054,"Target factor is corrupt - select
defaults"
-9055,"Only a restricted setting
allowed"
-9056,"No frequency change allowed"
-9057,"Time marker period too big"
-9058,"Time marker period too small"
-9059,"Invalid no. of divisions"
still