Fluke 9100 User Handbook Manual page 144

Final Width = 215mm
8-12 Section 8: Model 9100 — Routine Maintenance and Test
8.3.2 Fast/Full Selftest
Both Fast and Full selftests follow the same format. By pressing the
screen key on the '
Select required test
The first screen shows the pathway under test and the number of tests remaining, for the
selected selftest:
Selftest
Running FAST test.
Testing pathway no. XXX.XXX
Tests remaining: XX
TODAYS DATE TIME
A B O R T
8.3.2.1 Aborting the Selftest
stops the selftest and displays the appropriate '
ABORT
Selftest.
Test ABORTED with no failures.
TODAYS DATE TIME
E X I T P R I N T
If there were no failures up to the point of aborting, this is shown on the screen.
EXIT returns to the ' Select selftest
prints out the results of the test, up to the point of aborting.
PRINT
Refer to Sub-section 8.4.
If failures were encountered up to the point of aborting, EXIT and PRINT are available.
Also, the number of failures is shown on the screen, and an extra selection will be
available:
VIEW FAILS sets up a special screen for detailing the parameters of the failures
encountered (described later in Paras 8.3.2.3).
FAST
' menu screen, the 9100 runs the selected selftest.
Selftest.
Running FULL test.
Testing pathway no. XXX.XXX
Tests remaining: XX
TODAYS DATE TIME
A B O R T
' screen:
ABORTED
Selftest.
Test ABORTED with failures.
Number of failures: XX
Use the softkeys to view the results.
TODAYS DATE TIME
E X I T P R I N T
' menu screen.
or FULL
VIEW
FAILS