Fluke 9100 User Handbook Manual page 146

Final Width = 215mm
8-14 Section 8: Model 9100 — Routine Maintenance and Test
8.3.2.3 Viewing the Test Results
By pressing the screen key, each of the failed tests can be viewed in turn,
VIEW FAILS
on a screen which shows the test number (pathway), averaged measured value, upper
and lower limits, and the values of the two measurements which were used to derive the
'Measured value'. A brief description of the test is also given.
The screen for viewing the test results is shown below. This can also be used when a
test has been aborted.
Selftest.
Test no. XXX.XXX FAIL.
Measured value: XXXXXXX
Upper Limit:
Lower Limit:
Measurement A: XXXXXXX
Measurement B: XXXXXXX
(Description
TODAYS DATE
E X I T P R I N T
N.B. If the cause of failure is not immediately obvious, and it is intended to consult
your Fluke Service Center, please ensure that you either: copy the details
from the screen for all the reported failures, or: print out the results. No second
viewing of the same failure is allowed, although all the test results remain
available for printing.
NEXT FAILURE
Once the details of the first failure have been noted, the next failure in the list can be
viewed by pressing the
NEXT FAILURE
failures is allowed. Once the last failure in the list is on the screen, and the
FAILURE screen key is pressed, the following error message will appear in the top right
of the screen:
No more failures
to view
Pressing the NEXT FAILURE screen key will have no further effect. The user must either
exit back to the 'Select selftest' screen, or print out the results.
8.3.2.4 Printing the Test Results
The screen key is present on all screens after the test has run to completion or has
PRINT
been aborted. Pressing the PRINT key will print out all the available results.
Printing will only be possible if a suitable printer is set up, connected and on line. Refer
to Sub-section 8.4.
XXXXXXX
XXXXXXX
of test)
TIME
NEXT
FAILURE
screen key. Only one pass through the list of
NEXT