How To Manage Print Jobs; Daily Start-Up And Shut-Down - Oce Arizona 200 GT User Manual

How to Manage Print Jobs

Daily Start-up and Shut-down

Introduction
Keep your printer clean and perform all recommended scheduled maintenance to ensure
that the printer is ready to produce optimal quality images.
When to do
The start-up procedure must be performed every morning or after a period of time when
the printer has not been used. The shut-down procedure indicated here is for the end of
a regular workday. If the printer is shut down for longer periods of time than a few days,
then there are more considerations, as documented in the previous section on How to
Switch the Printer Off (see the note on Extended Power Off).
Before you begin
Review the sections on hardware and software interface if you are not familiar with the
Command Toolbar and other components mentioned in this section.
Start-up Procedure
Turn on the Ink Heater (click on the Ink Temperature Control icon located on the
1.
Command Toolbar of the Job Control screen).
Clean the carriage underside (See
2.
Perform Printhead Maintenance
3.
temperature has reached at least 40° Centigrade.
Shut-down Procedure
Turn off the UV lamps (click on the lamp icon located on the Command Toolbar of the
1.
Job Control screen).
Turn off the table vacuum.
2.
If it is the end of the work week, swab the printheads
3.
Turn off the ink heater (click on the Ink Temperature Control icon located on the
4.
Command Toolbar of the Job Control screen).
'Clean Carriage Underside' on page
(See'Printhead Maintenance' on page
Chapter 5 - How to Operate the Océ Arizona 200/250/350 GT
Daily Start-up and Shut-down
220).
214) after the ink
('Swab Printheads' on page 223
83