How To Power The Printer On And Off - Oce Arizona 200 GT User Manual

How to Power the Printer On and Off

Introduction
This section describes how to switch the printer On and Off. When the printer is switched
On, the Océ Arizona 200/250/350 GT software is displayed on the LCD display that is
located on the Operator Control Station. From there the operator can access and control
the printer. We recommend that you leave the printer powered on at all times. However,
if the printer is switched Off for long periods, there are things to consider that are docu-
mented in this section.
Before you begin
Before you apply AC power to the printer, make sure that loose objects such as clothing,
tools and cleaning materials are not interfering with the printer mechanisms. Position
the power cord so that it does not pose a hazard when walking around or moving media
or other objects near the printer. The Océ Arizona 200/250/350 GT has an AC power
switch that turns the printer On or Off. The switch also functions as an AC power lock-
out switch. It is located at the Power end of the printer.
Caution:
THE SOCKET OUTLET MUST BE INSTALLED NEAR THE EQUIPMENT AND
BE EASILY ACCESSIBLE. Ensure that you follow the guidelines in the Océ Arizona
200/250/350 GT Site Preparation Guide before plugging the printer AC power plug into
the socket.
Attention:
Unplug the blue power cord from the printer to completely isolate the electronics of the
printer, especially when you move or service the printer.
How to Power ON
Ensure that the blue AC power plug is properly seated.
1.
Turn on the AC power On/Off switch.
2.
If it is not already on, turn on the power of the Control Station LCD display.
3.
During the boot-up procedure, the printer operating system is loaded and the printer
4.
software is automatically started. The software displays a splash screen followed by a screen
that requests you to raise and then lower the carriage guard.
Chapter 5 - How to Operate the Océ Arizona 200/250/350 GT
How to Power the Printer On and Off
75