Chapter 4; How To Navigate The User - Oce Arizona 200 GT User Manual

Print Job Control Module
Roll Media
Manager icon
White Ink
Icon
Ink Tempera-
ture Control
UV Curing
Lamp Control
Button
Table vacuum
button
Start Button
Nozzle check
60 Chapter 4 - How to Navigate the User Interface
The Roll Media Manager allows the operator to load and unload
media and to initialize the printer so that the tension on the roll
media is set and the job is ready to print.
If the White Ink option is installed on the Océ Arizona 350 GT
press this icon to temporarily make white ink Inactive (do this only
if you do not plan to print any images with white for more than a
few hours). Always perform a swab and printhead maintenance at
least once a day and also when white ink is re-Activated after being
inactive.
This button controls the ink heater and also displays the ink tem-
perature. The state of the button reflects the status of the ink heater.
The heater times out after two hours of inactivity (time can be
changed up to four hours by a service technician). If the ink heater
is turned off when timeout expired, then the button changes its
status to unchecked.
The print heads must be at operating temperature (47°C - 116°F)
before a job will start printing.
This button controls the UV curing lamps. The state of the button
reflects the state of the lamps. The UV lamps will timeout after 15
minutes of inactivity (time can be changed by a service technician).
If lamps are extinguished when the timeout expired, then the button
change its status to unchecked. If lamps are off before the print
starts, then lamps are turned on automatically and the button would
reflect the state accordingly.
This button controls the table vacuum and duplicates the function
of the table vacuum foot switch. The button reflects the actual state
of the table vacuum. There is an automatic timeout that will turn
the table vacuum off. The actual time is set in the Settings module
under printer.
Note:
Once turned off, vacuum cannot be turned on again for
approximately 5 seconds.
This icon can be used to start a flatbed print job (same function as
the physical button on the table).
This button populates the active job list with a job that prints a
nozzle check pattern. The nozzle check print is used to identify
nozzle dropouts that can cause banding and other print quality
problems, '' on page ?.