Oce Arizona 200 GT User Manual page 77

Note:
The printer is designed to be left powered ON at all times as only minimal power is
consumed when the printer is idle.
How to Power Off
Turn the AC power switch to the OFF position.
1.
Close the purge valves on top of the Carriage ink reservoir to prevent the ink from
2.
draining out and filling the waste tray.
[48] Vacuum Shutoff Valves (Magenta, Yellow are Off - Black, Cyan still ON)
Open the purge valves again when the power is turned back on.
3.
Note:
Avoid Extended Power Off
If the power is switched off for only a short period (for example, when the printer is shut
down and then immediately restarted to correct an electrical problem or other trou-
bleshooting), it is not necessary close the ink valves. However, if it is necessary to turn
off the power for an extended period, then close all of the purge valves to prevent the
ink from draining. Also if the printer is powered off for more than one day, perform a
Printhead Maintenance and Swab the printheads before power is turned off. We recom-
mend that you leave the printer powered On at all times.
How to Lock Out the Power Switch
Attention:
Some service procedures require locking out the On/Off switch to ensure operator safety.
When the switch is locked out, it is impossible to supply power to the printer.
Chapter 5 - How to Operate the Océ Arizona 200/250/350 GT
How to Power the Printer On and Off
77