How to Power the Printer On and Off
Walk over to the carriage and lift the aluminum guard slightly and then replace it. Walk
5.
back to the control station and click on Continue to finish the boot-up procedure.
[47] AC Power Switch
The splash screen will show some further initialization messages and then the initial Job
6.
Control module screen appears. The initialization is complete when the top left panel of
the display shows "Ready". Your printer is now ready for use.
Attention:
After powering the printer On, leave it running continuously, even when at idle. Failure
to leave the printer powered on may result in ink draining out of the ink reservoirs. It
may also result in damage to the printheads. Leave the printer powered On at all times,
unless service to electrical components is required.
76
Chapter 5 - How to Operate the Océ Arizona 200/250/350 GT