Maintenance Procedures; Printhead Maintenance - Oce Arizona 200 GT User Manual

Printhead Maintenance

Maintenance Procedures

Printhead Maintenance
Introduction
The Maintenance Station is located below the carriage. Printhead Maintenance takes
place while the carriage is parked. The station is covered by a sliding door that has an
open grid in the center that allows any waste ink to drip down through the station and
into the waste tray. When you perform printhead maintenance, any excess ink and asso-
ciated debris are removed from the nozzles with the result that ink drops can jet properly
when the nozzles are clear.
Ink fill is disabled when the maintenance station sliding door is open. No more than 4
purges can take place (minimum of 10 seconds between purges) without closing the
cover plate and allowing the reservoirs to refill. Multiple purges are not required.
Note:
The nozzle plate on the printhead has a non-wetting coating - contact with this surface
may affect the performance of the printhead. Do not wipe the nozzle plate with anything
other than the suction-head (or the supplied swabs when following the swab procedure)
as this can damage the nozzles and impair performance.
Purpose
To clean the nozzles of the printheads and thus ensure better image quality and avoid
banding.
When to do
Maintenance occurs at the start of the day (after the printer has warmed up) or when
necessary (misfiring nozzles, banding in image, etc.).
Note:
More maintenance is required in dusty environments, or when there are fibres protruding
from the media, or when printing on transparent media (more reflected UV light hits
the printheads).
214 Chapter 11 - Printer Maintenance