Oce Arizona 200 GT User Manual page 115

Accurately center the media using the supplied ruler. Media should be centered within
5.
1mm on the ruler (or 5mm if you use the edge detector sensor.
[65] Ruler to Center Media
Note:
The supplied ruler has both metric (millimeters) and imperial (inches) scales. When a
media roll is centered on the shaft, and the ruler is placed as shown in the photo, the
value on the ruler scale will match the width of the roll. For example, in the photo a 2
meter (or 2000mm) roll is centered on the media shaft.
Lock the supply media shaft core locks with the 5mm hex key.
6.
B: Load an Empty Core and Install in the Take-up Position
Place the empty take-up media shaft on a suitable work surface and unlock the media
1.
shaft locks with the 5mm hex key.
Slide an empty media core that is at least as long as the supply media width onto the take-
2.
up shaft.
Roughly center the core and then insert the shaft into the Take-up (top) position on the
3.
RMO unit.
Center the core using the supplied ruler so that the take-up media can be aligned to the
4.
supply media roll when it is later threaded.
Lock the take-up media shaft core locks with a 5 mm hex key.
5.
Chapter 6 - How to Operate the Roll Media Option
How to Load Media
115