Oce Arizona 200 GT User Manual page 133

Bend the height adjustor (small triangle in the top corner of the edge protector) slightly
3.
and then straighten it again. This results in a slight bend (no more than a media thickness),
that allows the media edge to move more freely under the protector.
Attention:
If the height adjustor area is higher than 1 mm from the platen, there is a possibility of
the carriage may hit the edge of the protector and thus damage printhead nozzles.
Peel the backing layer from the double-sided tape on the back of the protector.
4.
Place the bent edge of the protector into the media cut guide, but do not press down on
5.
the tape yet.
Slide the protector towards the media edge until the inside edge of the height adjustor is
6.
positioned over the media edge (see Figure 2).
Note:
Do not let the plastic edge near the arc butt up against the media edge or the device may
not let the media pass smoothly.
The vacuum in the platen will hold the main part of the protector in place while the image
is printed.
Press down on the tape to fasten the protector in this position.
7.
Note:
The adhesive on the edge protector can be re-used approximately ten times. If you find
that it is not holding the protector in place, then use a new one.
Result
The media edge protectors will reduce the amount of fiber and other debris. However,
it is important to keep the platen and cutting guide areas clean as indicated in the Roll
Media maintenance section.
How to Deal with Wide Media
If you use media of the maximum width for the RMO (2.2m or 7.2 feet) that requires
media edge protection, you can cut the protectors in half in order for them to fit.
Chapter 6 - How to Operate the Roll Media Option
How to Use Media Edge Protectors
133