Oce Arizona 200 GT User Manual page 93

Note:
Make sure that you support the middle parts of the overlay so that you don't bend or
warp it, as shown in the photo. If it does warp you may have to turn it over and leave it
to settle for a while until it is completely flat.
[58] How to Handle the Overlay
With one hand on the top and the other on the bottom, carefully flip the overlay over
3.
and lay it down flat on the table (or another clean, flat surface).
Remove any old foam tape that is no longer required in the new configuration.
4.
Clean the area of the overlay sheet where the new foam tape is to be applied with isopropyl
5.
alcohol.
Measure and add tape (part # 3010106701: gray silicone foam tape) in the desired locations
6.
to create zones. When you create a zone we recommend that active vacuum holes are a
Chapter 5 - How to Operate the Océ Arizona 200/250/350 GT
How to Create Custom Vacuum Zones
93