Chapter 4; How To Navigate The User - Oce Arizona 200 GT User Manual

Cancel job The command can do following actions depending on context:
Delete job Deletes a job from the printer. However, you cannot delete a job
that is currently printing.
Flatbed icon Process flatbed jobs toggle command - Allows printer to process
flatbed jobs. This must be selected to enable flatbed printing when
the printer is booted or after re-setting the printer due to an error.
Flatbed Set- A dialog window automatically appears when confirmation is re-
tings icon quired. If it is closed before you select Confirm, it can be reopened
by clicking on this icon.
Media Parameters
Enter or confirm the thickness of the media. The printer will auto-
matically adjust the carriage height to media thickness and also the
print gap. Media thickness confirmation is required only for the
first copy of a print job, unless it is changed during printing. If the
media thickness value is changed while printing, confirmation is
requested before printing the next copy. If you use a media underlay
('Underlay Board to Reduce Artifacts' on page
to add its thickness to the overall media thickness. If the underlay
has a different thickness than the one shown, then change that
value in the Roll Settings dialog in the Settings module.
Lamp Power Control
Allows the operator to control the power output of each UV lamp
independently. To extend lamp life, use the lowest setting that
provides adequate curing for a particular media. Leading and
Trailing Edge are relative to the direction of carriage travel. They
can be set independently if that function is selected in the User
Interface dialog in the Settings module.
Roll icon Click on the Roll icon to enable or disable the Roll Media Option
print queue (this allows you check media parameters before the job
actually prints). Roll media print jobs will not print unless this icon
is selected.
Deactivates a selected active job by moving it to the inactive
list.
Cancels a currently printing job and moves it to the inactive
list.
Note:
Roll media print jobs do not require explicit user actions
to start the print job once it is initialized, this icon is select-
ed, and the job status is not on Hold.
Chapter 4 - How to Navigate the User Interface
Print Job Control Module
99) click on that box
59