Oce Arizona 200 GT User Manual page 138

Reduce Static with a Static Suppression Kit
Loosen the bracket mount screw and then slide the bracket up in the keyed slot to remove
3.
it.
[78] Bracket Mounted Low
Turn the bracket 180 degrees and then fit the other keyed slot over the bracket screw.
4.
Slide the bracket mount until the screw is located in the smaller end of the keyed slot.
5.
[79] Bracket Mounted High
Make sure the bracket is level an then tighten the bracket mount screw.
6.
Repeat Steps 2 to 5 until all four mounts are reversed.
7.
Result
The printer can now use media with a maximum thickness of 38mm (1.5 inches).
138 Chapter 7 - How to Use the Static Suppression Upgrade Kit