Oce Arizona 200 GT User Manual page 106

Roll Media Option Specifications
This allows for a minimum 5mm (0.2") border. This is necessary to ensure the platen is
not contaminated with ink due to possible media tracking errors. Cured and uncured ink
on the platen will have a serious effect on printer performance. Any spilled ink must be
removed immediately (See RMO Maintenance section). If an image exceeds the 5mm
border requirement, printing will not be allowed to proceed.
Maximum Media Thickness
This value is not officially specified. It is theoretically possible for the RMO system to
accommodate media up to 3mm (0.11 inches). However, most media at or near that
thickness will have problems in the transport mechanism of the RMO unit.
Maximum Supported Weight
#
Media Width (mm)
900 ≤ x < 1220
1220 ≤ x < 1480
1480 ≤ x < 1780
1780 ≤ x ≤ 2200
Leader & End of Roll Waste
Leader Waste: 560mm (22 inches)
Leader waste is the amount of media that cannot be printed between the roll media
platen and the take-up media roll. This waste is produced every time media is loaded,
taped to the take-up core and initialized in preparation for the first print. Trailer waste
is the media that cannot be printed at the end of the supply media roll. This will vary
slightly depending on the attachment method that was used to secure the media to the
media core.
End of Roll Waste (minimum possible): 920mm (36 inches)
End of roll waste is the media that cannot be printed at the end of the supply media roll.
This will vary slightly depending on the attachment method that was used to secure the
media to the media core.
106 Chapter 6 - How to Operate the Roll Media Option
Max. Weight kg (lbs)
28 (62)
40 (88)
45 (100)
50 (110)