How To Manage Print Jobs; Daily Start-Up And Shut-Down - Oce Arizona 250 GT User Manual

Daily Start-up and Shut-down

How to Manage Print Jobs

Daily Start-up and Shut-down
Introduction
Keep your printer clean and perform all recommended scheduled maintenance to
ensure that the printer is ready to produce optimal quality images.
When to do
The start-up procedure must be performed every morning or after a period of time
when the printer has not been used. The shut-down procedure indicated here is for
the end of a regular workday. If the printer is shut down for longer periods of time
than a few days, then there are more considerations, as documented in the previous
section on How to Switch the Printer Off (see the note on Extended Power Off).
Before you begin
Review the sections on hardware and software interface if you are not familiar with
the Command Toolbar and other components mentioned in this section.
Note: Make sure the ink is up to temperature before you perform Printhead
Maintenance.
Start-up Procedure
Turn on the Ink Heater (click on the Ink Temperature Control icon located on the
1.
Command Toolbar of the Job Control screen).
Clean the carriage underside
2.
Perform Printhead Maintenance Printhead Maintenance) after the ink temperature
3.
has reached at least 40° Centigrade.
Shut-down Procedure
Turn off the UV lamps (click on the lamp icon located on the Command Toolbar of
1.
the Job Control screen).
Turn off the table vacuum.
2.
If it is the end of the work week, swab the printheads
3.
page 107)
Turn off the ink heater (click on the Ink Temperature Control icon located on the
4.
Command Toolbar of the Job Control screen).
72 Chapter 5 How to Operate the Arizona 250 GT
((see 'Clean Carriage Underside' on page 110)
((see 'Swab Printheads' on