Print A Nozzle - Oce Arizona 200 GT User Manual

Print a Nozzle Check
Required tool
Blue LED view light (sometimes needed to enhance contrast in the Yellow area).
Océ I/O paper
Note:
Usually, two or more Nozzle Checks will be printed to verify that nozzle issues are re-
solved. To calculate the required offset when you print multiple consecutive nozzle
checks, add a horizontal offset of 2.5" or 60 mm to each consecutive print.
How to Print the Nozzle Check
Place a piece of Océ I/O paper on the printer table.
1.
Select the Nozzle Check icon at the right end of the Command Toolbar to place the
2.
nozzle check into the Active Print Job list (you can also add a Nozzle Check to the active
print list when you select it from the Special Prints module).
Modify the horizontal offset (only if a previous nozzle check was printed on the same
3.
piece of media).
Confirm media thickness.
4.
Activate the table vacuum.
5.
Push the printer Start button to begin the print.
6.
Check
The Magenta section of the Nozzle Check print shown in the figure below indicates that
1.
multiple nozzles are out.
[162] Nozzle Check Print Magenta Section
244 Chapter 11 - Printer Maintenance