Oce Arizona 200 GT User Manual page 201

Océ Arizona 200/250/350 GT Ink
supply ink to the reservoirs on demand. Float sensors in the reservoirs control the level
of ink and initiate demand when required. Ink temperature control is achieved by
pumping a coolant fluid through the ink reservoir block and printheads. An internal
thermostat on each printhead and one on the reservoir block provides temperature feed-
back.
The condition of the printheads is maintained by periodic cleaning at the maintenance
station on the gantry. During this procedure the operator suctions the printhead nozzle
plates, removing ink and possible contaminates in the process (details of this procedure
are available in the Maintenance section'' on page ?).
UV Flush
UV Flush is used as a cleaning agent for the printheads or to flush the ink lines of ink for
a printer relocation or long-term storage.
Attention:
Do not install inks that are not certified by Océ Display Graphics Systems for use in this
printer, as this may result in:
Poor quality prints, uncured ink in the finished prints (NOTE: This is a serious health
and safety risk!), and permanent damage to the ink pumps, filters, ink lines or printheads.
Chapter 9 - Ink System Management 201