Oce Arizona 200 GT User Manual page 81

After the printer driver is installed the Configure Printer Port window will launch auto-
6.
matically. Select TCP/IP Printer then click on Configure.
[50] Configure Printer Port
Enter the Network name of the printer (as displayed in Step 3) and make sure <Port
7.
9100> is selected for the port.
[51] Configure Printer Host Name
Note:
If you have more than one Océ Arizona 200/250/350 GT printer, each printer must
have a unique network name. The network name can be changed in the Settings module
of the printer User Interface.
Check Configuration
Click on Test to verify that the computer and printer are in communication.
1.
If the Test was successful, a verification message is displayed to indicate a Valid IP address
was found.
Chapter 5 - How to Operate the Océ Arizona 200/250/350 GT
How to Install the Onyx Printer Driver
81