Chapter 4; How To Navigate The User - Oce Arizona 200 GT User Manual

Print Job Control Module
The operator can drag and drop jobs to move them between the active and inactive
job lists.
Jobs deleted from the inactive list are deleted from the hard drive.
9) Job information and parameters panel
The job information area displays only relevant job parameters of the current print job.
For example, the Overprints field is not displayed for roll media jobs. Some of the param-
eters may be modified.
#
Offsets
62 Chapter 4 - How to Navigate the User Interface
A job's vertical and horizontal offset parameters can be
changed with the mouse wheel when mouse cursor is posi-
tioned over the field. Rotate the mouse wheel up or down
increments or decrements offset at the rate of one unit per
notch. Hold the right mouse button and rotate the wheel
increments or decrements at the rate of 10 units per notch.
An alternate method to change parameter values is to click
on the field and this brings up an onscreen keyboard so you
can click on the numbers required.