Oce Arizona 200 GT User Manual page 237

Insert the new ink filter in the metal retainer clips in the upright position (this means
15.
that the white bleed cap is at the bottom). Be careful not to pinch the ink lines.
Final Steps
Check the new filter to make sure there are no ink leaks.
1.
Open any purge valves on the carriage that are still closed.
2.
Replace the ink filter enclosure cover.
3.
Perform routine printhead maintenance before printing.
4.
Use a felt pen or create a sticky label to record the install date and liters consumed (refer
5.
to the Counters module for a liter count)
Replace the filter every 10 months or after consumption of 22 litres of ink.
6.
How to Change Ink Filters
Chapter 11 - Printer Maintenance 237