Product Compliance - Oce Arizona 200 GT User Manual

Product Compliance

Product Compliance
Introduction
This section details the compliance and agency standards that the Océ Arizona
200/250/350 GT conforms to. It also provides manufacturing and contact information.
Electromagnetic Compliance (EMC)
FCC Statement for Class A Device:
This equipment generates, uses and radiates radio frequency energy and if not installed
and used as designed or intended, may cause interference to radio communications. This
equipment has been tested and found to comply with the limits for a Class A computing
device. This equipment has been designed to provide reasonable protection against such
interference when operated in residential and commercial environments. Operation of
this equipment in a residential area may cause interference, in which case the user, at his
own expense, is required to take whatever measures are required to correct the interference.
FCC Notice: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may
cause undesired operation.
Any change or modification not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
This device contains an intentional radiator (RFID)
Radio Certificate Number: IC:6497A-3010105668
FCC Identifier: U2P-3010105668
Product Safety
Compliance Category.
This equipment is considered to be information technology equipment for use in a light
industrial setting. The equipment falls under the scope of the Machinery Directive due
to the movement associated with the gantry carrying the printer head carriage assembly.
As such, a full risk assessment per EN 1050 and a full mechanical and machinery assess-
ment per 292-2 + A1 Annex 1 was performed. As the equipment is primarily information
technology equipment (large format printer receiving data from a computer terminal),
and is within the scope of EN 60950 (mains operated ITE equipment under 600V in-
cluding plotters and photo printers - clause 1.1.1, EN 60950: 2000), a full electrical
evaluation was performed per EN 60950:2000.
12 Chapter 1 - Introduction