How To Power The Printer On And Off - Oce Arizona 250 GT User Manual

How to Power the Printer On and Off

Introduction
This section describes how to switch the printer On and Off. When the printer is
switched On, the Arizona 250 GT software is displayed on the LCD flat panel
monitor. The monitor is located on the Operator Control Station. From there the
operator can access and control the printer Graphical User Interface Display. When
the printer is switched Off for long periods, there are things to consider that are
documented in this section.
Before you begin
Before you apply AC power to the printer, make sure that loose objects such as
clothing, tools and cleaning materials are not interfering with the printer
mechanisms. Position the power cord so that it does not pose a hazard when walking
around or moving media or other objects near the printer. The Arizona 250 GT has
an AC power switch that turns the printer On or Off. The switch also functions as
an AC power lock-out switch. It is located at the Power end of the printer.
Caution: THE SOCKET OUTLET MUST BE INSTALLED NEAR THE
EQUIPMENT AND BE EASILY ACCESSIBLE. Ensure that you follow the
guidelines in the Arizona 250 GT Site Preparation Guide before plugging
the printer AC power plug into the socket.
Attention: Unplug the blue power cord from the printer to completely isolate
the electronics of the printer, especially when you move or service the printer.
How to Power the Printer On and Off
73